Post by Daremo on Oct 7, 2012 18:08:33 GMT -5
Step 1. Tools and Supplies:
Wire Cutter
Small Saw
Hobby Knife
Tweezers
Super Glue
Sand Paper/File
3/32" Tube
4 jackstay eyebolts 1/16" x 1/2" (modelexpo-online.com - MS0428)
Chain 21 links per inch (modelexpo-online.com - MS0480)
Step 2. Cut:
Take the 3/32" tube and cut 3 sections (1 1/2") with the saw. Using the saw will allow you to avoid any crushing of the tube when you cut it. Sand the ends of the tubes. Cut 2 sections of chain (5 links each).
Step 3. Attach:
First, we'll attach the chain to the eyebolts. I take a hobby knife to open the jackstay eyebolt up (pics here post #5). Then stick the long end of the eyebolt through the chain until it reaches the eye and close it back up with your fingers or tweezers. Repeat this 3 more times so you end up with 2 sections of chain with eyebolts on each end. Now take one of the tubes that you cut and glue eyebolts to each end of it. Glue the other 2 sections to each remaining eyebolt.
Step 4. Paint:
Once everything has been attached and the glue has dried, it's time to paint. I'm using Testors Model Masters Acrylics. First, prime the weapon. Then paint the whole thing flat black. Paint the chains steel. Once the paint dries, seal it with Testors Glosscote or Dullcote.
Wire Cutter
Small Saw
Hobby Knife
Tweezers
Super Glue
Sand Paper/File
3/32" Tube
4 jackstay eyebolts 1/16" x 1/2" (modelexpo-online.com - MS0428)
Chain 21 links per inch (modelexpo-online.com - MS0480)
Step 2. Cut:
Take the 3/32" tube and cut 3 sections (1 1/2") with the saw. Using the saw will allow you to avoid any crushing of the tube when you cut it. Sand the ends of the tubes. Cut 2 sections of chain (5 links each).
Step 3. Attach:
First, we'll attach the chain to the eyebolts. I take a hobby knife to open the jackstay eyebolt up (pics here post #5). Then stick the long end of the eyebolt through the chain until it reaches the eye and close it back up with your fingers or tweezers. Repeat this 3 more times so you end up with 2 sections of chain with eyebolts on each end. Now take one of the tubes that you cut and glue eyebolts to each end of it. Glue the other 2 sections to each remaining eyebolt.
Step 4. Paint:
Once everything has been attached and the glue has dried, it's time to paint. I'm using Testors Model Masters Acrylics. First, prime the weapon. Then paint the whole thing flat black. Paint the chains steel. Once the paint dries, seal it with Testors Glosscote or Dullcote.